1. Home
  2. Docs
  3. H60 Gateway Manual
  4. Operations

Operations

Husdata Online (if enabled)

When H60 is installed and all seem to work according to LED statuses and web page, it will start uploading statistics to the Husdata online system every 5 minutes.

Log in to Husdata.se with the by mail supplied account to view real-time information, build reports and configure notification for certain thresholds. It will take 5 minutes before you see the first data.

H60 Web interface

Menu-Home
Status
Gives you an overview of your H60 status like its Version, Signal strength, Uptime and statistics.

Heat pump status, parameters and data
A list of the heatpump sensors and status for the heat pump and their current value is shown.

Heat pump settings
In the list there are grey marked rows. These are settings you can change in the heat pump. For example indoor temp and heat curve settings. The boundaries (max/min) valkues to set can be shown putting the mouse over the Index number.

Manage power setting.
For on/off registers and Percantage register you can set its power consumtion to track the Pumnps energy usaage.
See the Power measurement guide for more info

Manage custom registers
At the bottom of the page you have the link to customer registers page. This is for advanced users that would like to add additional registers to read from pump. See separate guide for custom registers.

Menu-Config
View and make changes to the configuration. See full parameter list in other section of this manual.

Menu-Log
View about 60 of the last messages from the H60 system. The log will reset it self when it gets too large. If first startup log is getting too long it will be stored under the ”Startup” log button before cleared. So you can always access the startup information. The Log if very useful for troubleshooting and verification of operations.

Menu-Support

Support Ticket
Use the ticket function of you like to ask a question or need help. Check the box for Configuration to include it in the ticket. You will get a copy by mail.

Remote Assistance
The H60 can connect to Husdata support server over an agreed port. This enable Husdata to remotely access the H60 for development or sorting out problems with the unit. To enable Remote Assistance, enter the port number that has been agreed with Husdata as part of the case.

Update H60 firmware
View the current version, release-notes and new available version of the H60 firmware. If they differ you can update your unit by selecting the “UPDATE” button. The update takes 20-30 sec. Wait one minute before trying to access to unit after an upgrade and verify that it has got the new version installed. Please don’t disconnect the H60 from power while it is updating. After update, please view the Configuration if there are any new parameters that has been added needing attention.

Update H1 firmware
H1 is the slave-processor of H60 handling heat pump low level communications. If there is an update available it will be shown here. Always make sure both the H60, and H1 firmware are updated as they work together.

Run console command
For advanced troubleshooting and management, the H60 has a command-line interface (CLI) available when connecting it to its USB/Serial port. Here you can run CLI commands from the web interface. Note that the CLI response will not be visible via web interface. See specific CLI section for more information.

Factory reset config:
Use to reset different parts of configuration to factory config if H60 if needed

Restart the unit
Restart the H60

Menu-Logout

Logging out from H60 if password is enabled

How can we help?